Jet Tools M-708640 User Manual Page 1

OWNER'S MANUAL DC-650A Dust Collector WMH TOOL GROUP Consumer/Light Industrial Products Division P.O. BOX 1349 Auburn, WA 98071-1349 Ph: 1

10Removing the Collector Bag CAUTION Wearing a particle mask/respirator for protection against fine dust particles during cleaning is highly recommen

11Parts Breakdown for DC-650A Dust Collector

12Parts List for the DC-650A Dust Collector Index Part No. No. Description Size Qty. 1...422109W ... Impeller Hous

13Wiring Diagram

2This manual has been prepared for the owner and operators of JET’S DC-650A. Its purpose, aside from machine operation, is to promote safety through

3 WARNING 1. Read and understand the entire contents of this manual before attempting assembly or operation. Do not use this machine until proper

4Grounding Instructions Caution: This tool must be grounded while in use to protect the operator from electric shock. In the event of a malfunction

5230 Volt Operation If 230V, single phase operation is desired, the following instructions must be followed: 1. Disconnect the machine from the pow

6Specifications: DC-650A Stock Number...

7 WARNING Read and understand the entire contents of this manual before attempting assembly or operation of the dust collector! Failure to comply may

8Assembly WARNING The dust collector must be disconnected from the power source during assembly. Failure to comply may result in serious injury! 1.

97. Thread a M6 hex nut onto the filter bag support rod, follwed by a M6 flat washer and M6 lock washer (A, Fig. 5). Thread the support rod (B, Fig.