Jet Tools 719T WMH User Manual

Operating Instructions and Parts Manual Tilting Table Hollow Chisel Mortiser Model: 719T WMH TOOL GROUP 2420 Vantage Drive Elgin, Illinois 60

10Electrical Power Connection Do not operate this machine in damp locations. A separate electrical circuit should be used for your machines. This ci

11Adjustments 90° Chisel to Worktable Calibration Referring to Figure 7: Place a square (E) so it rests against the worktable (B) and chisel (A). If

126. Reinstall the chisel bushing (F) and secure it loosely with the lock screw (E). 7. Reinstall the chisel and bit (refer to the Installing Chisel

13Chisel Parallel to Workpiece Referring to Figure 11: The chisel can be adjusted parallel to the workpiece as follows: 1. With the left handwheel

14 Do not have the chisel slot against the blind end of the mortise, as the chips will not be able to clear the chisel. This can cause overheating a

15three turns of the cutter in a carpenter's brace chuck should be enough to sharpen the chisel, as shown in Figure 16. Use a small, triangular,

16 719T Mortiser Parts List Index No. Part No. Description Size Qty ...2474002T...719T Mortiser Assy (Items 1 thru 12

17Index No. Part No. Description Size Qty 57 ...6294180 ...C-Clip ...

18Index No. Part No. Description Size Qty 114 ...TS-1491021 ...Hex Cap Screw ...

19719T Mortiser Stand Parts List Index No. Part No. Description Size Qty ...6294235T...Stand Assembly (Items 1 thru 8

2This manual has been prepared for the owner and operators of a POWERMATIC 719T Tilting Table Hollow Chisel Mortiser. Its purpose, aside from machine

20Optional Accessories Index No. Part No. Description ...6294232 ...Chuck Extension Adaptor Kit (Items 1 thru 3).

3Table of Contents Warranty and Service...

4 Warnings 1. Read and understand the entire owners manual before attempting assembly or operation. 2. Read and understand the warnings posted on t

5 blahblahblah 21. Make your workshop child proof with padlocks, master switches or by removing starter keys. 22. Give your work undivided attention

6Introduction This manual is provided by POWERMATIC covering the safe operation and maintenance procedures for a Model 719T Tilting Table Hollow Chis

7Unpacking Remove mortiser and stand from the shipping cartons. Check for damage and ensure all parts are intact. Any damage should be reported imme

8Assembly Do not connect the machine to power source until completely assembled. Read and understand the entire manual. Securing Machine to Stand Th

9Installing Chisel and Bit Referring to Figure 3: 1. Loosen the lock screw. 2. Insert the chisel bushing into the head with the hole facing forward