Jet Tools DC-1200CK User Manual

Operating Instructions and Parts Manual Dust Collector DC-1200 Series Dust Collectors DC-1200BK

10Connector Housing 5. Attach three support legs (A, Fig. 4) to the base using six M8 x 16 hex cap bolts and six M8 flat washers (B, Fig. 4). Hand-t

11Filter Bag Kit Assembly If you purchased Model DC-1200BK or DC-1200-3BK Dust Collector, this section describes the assembly and installation of the

12Canister Kit Assembly If you purchased Model DC-1200CK or DC-1200-3CK Dust Collector, this section describes the assembly and installation of the c

13Electrical Connections All electrical connections must be done by a qualified electri-cian. All adjustments or repairs must be done with the dust

14Changing Operating Frequency If several devices are controlled by the same type remote control unit, each remote control unit can be set to operate

15Maintenance Never perform maintenance on this machine before turning switch off and removing plug from power source. Failure to comply may cause se

 16 Parts List for the DC-1200M/DC-1200M-3 Index No. Part No. Description Size Qty 1 ... 411035W... Impeller Housing ..

 17 Parts Breakdown

 18Canister Filter Assembly Index No. Part No. Description Size Qty 1 ... 331050 ... Handle ...

 19Filter Bag Assembly Index No. Part No. Description Size Qty 1 ... 708698 ... Filter Bag ...

2 Warranty and Service Walter Meier (Manufacturing) Inc., warrants every product it sells. If one of our tools needs service or repair, one of our Au

 20Wiring Diagram For 3 Phase 230V/460V Dust Collector (DC-1200M-3) Wiring Diagram For Single Phase 230V Only Dust Collector (DC-1200M)

3 Table of Contents Warranty and Service ...

4 Warnings 1. Read and understand the entire owner's manual before attempting assembly or operation. 2. Read and understand the warnings post

5 20. Make your workshop child proof with padlocks, master switches or by removing starter keys. 21. Give your work undivided attention. Looking ar

6 Introduction This manual is provided by JET covering the safe operation and maintenance procedures for model DC-1200 Series Dust Collectors. This m

7 Unpacking The table below lists the shipping cartons that are included with the various models of the DC-1200 Dust Collector. 1. Locate your part

8 Canister Filter Kit (SN 708639B) 1 – Handle (O) 1 – Canister Filter (P) 1 – Snap Ring (Q) 5 – Collector Bags (R) 1 – Canister Filter Hardware Bag (

9 Base Unit Assembly Base 1. Install four casters to the under side of the base as pictured in Fig. 2. Referring to Figure 1: 2. Thread the hex nut (