Jet-tools JDS-12B User Manual download pdf (Page 9)

9

Stand Assembly (optional accessory)

1. Match the hole patterns in the stand legs

with the hole patterns in the stand supports.

Mount the legs to the outside of the supports

using sixteen M8x16 carriage bolts and

sixteen M8 flange lock nuts, figure 1. Do

not tighten until the stand has been

assembled and is sitting level on the floor.

2. Bolt the sander to the stand with four

M10x40 hex cap bolts, eight M10 flat

washers, four M10 lock washers and four

M10 hex nuts

Sander Assembly

1. Mount the sander to JET’s open stand with

four M10x40 hex head bolts, eight M10 flat

washers, four lock washers, and four hex

nuts. Tighten the nuts to secure the sander

to the stand.

Note: If you are going to use the sander as

a benchtop unit mount the sander to the

workbench with the supplied bolts.

2. Unscrew the knob (A, Fig. 2), remove the

washer (B, Fig. 2) and the trunnion holder

(C, Fig. 2). Repeat for opposite side.

3. Lift the table (D, Fig. 2) into position and set

on top of the split pins and threaded shaft.

4. Reinstall the trunnion holder, washer and

knob. Repeat for opposite side.

5. Make sure the trunnion and trunnion holder

engage and tighten the knob.

6. Place the gasket (E, Fig. 3) against the

sander base and mount the inlet port (F, Fig.

3) to the sander with four M6x16 hex cap

bolts (G, Fig. 3).

Warning

Avoid kickback by sanding in accordance

with directional arrow. Sand on downward

side of disc. Sanding on the upward side

could cause the workpiece to fly up causing

injury! Failure to comply may cause serious

injury!

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

Comments to this Manuals

No comments