Jet Tools JBTS-10MJS User Manual download pdf (Page 12)

Assembl

Note: The letter designators used in the assembly

section are the same as those used in the shipping

contents and hardware section (page 10-11) for the

purpose of simplifying part identification.

Stand

Stand may pop up unexpectedly

without weight of saw on stand. In order to

avoid injury, verify that the lock hook (G

, Fig.

7) located at the front of the stand is locked

onto the stop screw before mounting the table

saw.

Stand Pad and Pedal

Referring to figure 5:

1. Thread the stand pad (Z) through the wing nut

) to the bottom of the left rear leg.

Adjustment is described in Setting up the Stand

on page 17.

2. Attach the pedal (E) to the left front leg using

the screw (U) and hex nut (V). Secure with

10mm socket and crosspoint screwdriver.

Wheel

Referring to Figure 6:

3. Attach two collars (R

, R

) to each roller wheel

(M).

4. Attach one roller wheel assembly to the right

front leg using the bolt (Q), the shaft sleeve (S),

and the hex nut (T) as shown.

Note: Verify that the side of the wheel that has

more ribs is facing toward the inside of the

stand.

5. Attach the other roller wheel to the right rear

leg using the same manner.

6. Tighten screw (Q) and hex nut (T) with two

17mm wrenches.

Note: Do not overtighten, because doing so will

not allow the wheels to turn.

Attaching Saw to Stand

Referring to Figure 7:

Do not cut the bands and

release the stand hook (G

) until the table saw

is properly attached to the stand.

1. Place table saw (D) on the top of stand (G)

aligning the holes in the base with the holes in

the stand.

Figure 5

Figure 6

Figure 7

2. Insert four hex bolts (W) through the plastic flat

washers (X) and holes in base and stand.

3. Tighten all four bolts (W) with a 13 mm socket,

but do not overtighten.

Note: To set up the stand or fold down the stand,

see Setting Up The Stand and Folding The Stand

on page 17.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 39 40

Comments to this Manuals

No comments

Jet Tools JBTS-10MJS User Manual Page 12

Comments to this Manuals

Related products and manuals for Mitre saws Jet Tools JBTS-10MJS