Jet Tools JBTS-10MJS User Manual download pdf (Page 13)

Mounting the Saw to Work Surface

A hole to allow sawdust to fall

through must be provided when the saw is

mounted to a work surface (stand not used).

Failure to do so will cause sawdust to build up

in the motor area, which can result in fire or

damage to the motor.

Referring to Figure 8:

If the stand is not used, the saw must be properly

secured to a sturdy workbench through the four

mounting holes that are located at the base of the

saw.

The surface of the table where the saw is to be

mounted must have a hole (B) that is large enough

to facilitate sawdust fall-through and removal.

1. Square the saw on the mounting surface, and

mark the location of the four 3/8 in. mounting

holes (A).

2. Drill pilot holes in two diagonal corners (marked

(A) in the mounting surface.

3. Mark an 11x11 in. square (B), centered bet-

ween the four mounting holes (A).

4. Cut out and remove the square.

5. This opening will allow sawdust to fall through

the saw base.

6. Place the saw on the work surface, and align

the mounting holes of the saw with the two

holes drilled in step 2.

7. Fasten the saw to the work surface using

screws (Y, Fig. 4) provided.

Do not operate this saw on the

floor. Doing so is very dangerous. Failure to

comply may cause serious injury!

Rear Table Extension

Referring to Figure 9:

1. Attach the rubber pad (HH) to the inside of the

rear table extension (H). Thread the screw (GG)

thru the rubber pad with the screwdriver. Tighten

the screw (GG).

2. Insert the two rear table extension tubes (J) into

the rear table extension (H). Follow arrows J

, J

Note: The tubes (J) must be inserted into the

back of the extension with the bent end last so

that the bar will hold the extension in place.

3. Snap plastic stops (FF

) over the extension

tubes (J). This will ‘lock’ the tube (J) into the

extension (H). Make sure the pin in the stops fit

Figure 8

Figure 9

into the matching holes in the extension tubes.

4. Following arrows J1, J3, insert the rear table

extension into the two extension tube brackets

) under the table.

5. Snap two black plastic stops (FF

) over the end

of the rear table extension tubes (J). Make sure

the pin in the stops fit into the matching holes in

the extension tubes.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

Comments to this Manuals

No comments

Jet Tools JBTS-10MJS User Manual Page 13

Comments to this Manuals

Related products and manuals for Mitre saws Jet Tools JBTS-10MJS