Jet Tools HBS-56S User Manual download pdf (Page 11)

11

This band saw is pre-wired for 115 volt and is

equipped with an electric cord having an

equipment-grounding conductor and a

grounding plug similar to that shown in Figure 6.

The plug must be inserted into a matching outlet

that is properly installed and grounded in

accordance with all local codes and ordinances.

Do not modify the plug provided. If it will not fit

the outlet, have the proper outlet installed by a

qualified electrician.

Improper connection of the equipment-

grounding conductor can result in a risk of

electric shock. The conductor, with insulation

having an outer surface that is green with or

without yellow stripes, is the equipment-

grounding conductor. If repair or replacement of

the electric cord or plug is necessary, do not

connect the equipment-grounding conductor to a

live terminal.

Check with a qualified electrician or service

personnel if the grounding instructions are not

completely understood, or if in doubt as to

whether the machine is properly grounded. Use

only three wire extension cords that have three-

prong grounding plugs and three-pole

receptacles that accept the machine’s plug.

115 Volt Operation

As received from the factory, your band saw is

ready to operate at 115 volt power, using an

outlet and a plug that look similar to those

illustrated in Figure 6.

A temporary adapter, which looks like the

adapter illustrated in Figure 7, may be used to

connect this plug to a two-pole receptacle as

shown, if a properly grounded outlet is not

immediately available. The temporary adapter

should only be used until a properly

grounded outlet can be installed by a

qualified electrician.

The green colored rigid ear, lug or tab,

extending from the adapter must be connected

to a permanent ground such as a properly

grounded outlet box, as shown in Figure 7.

Check with a qualified electrician or service

personnel if the grounding instructions are not

completely understood, or if in doubt as to

whether the tool is properly grounded.

Make sure the voltage of your power supply

matches the specifications on the motor plate of

the Band Saw.

Conversion to 230 Volt

If 230 volt operation is desired, the following

instructions must be followed:

Figure 6

Figure 7

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Comments to this Manuals

No comments