OWNER'S MANUAL PDS-12CS 12” Disc Sander POWERMATIC 427 Sanford Rd. Phone: 253-351-6000 WMH Tool Group LaVergne, TN 37086 Fax: 1
10Collector Bag Assembly 1. Mount the inlet port (A, Fig. 4) to the cabinet with four M6x12 pan head screws (B, Fig. 4). 2. Thread two M6 nuts (C,
11Sanding Disc Replacement 1. Disconnect machine from the power source. 2. Remove the knobs (A, Fig. 7), washers (B, Fig. 7), and trunnion holder
12Emptying the Collector Bag CAUTION Wearing a particle mask/respirator for protection against fine dust particles during cleaning is highly recomme
13Base Assembly Breakdown
14Parts List for the PDS-12CS Base Assembly Index Part No. No. Description Size Qty 1...612083... Closed Stan
15Sander Assembly Breakdown
16Parts List for PDS-12CS Sander Assembly Index Part No. No. Description Size Qty 1...612111... Base...
17Index Part No. No. Description Size Qty 41...TS-1551061 ... Lock Washer ...M8 ..
18Wiring Diagram
2This manual has been prepared for the owner and operators of a PDS-12CS Sander. Its purpose, aside from machine operation, is to promote safety thr
3 WARNING Wear eye protection. Always keep guards in place and in proper operating condition. Do not operate the machine without the guards for an
4• ALWAYS DISCONNECT THE MACHINE FROM THE POWER SOURCE BEFORE SERVICING. • REDUCE THE RISK OF UNINTENTIONAL STARTING. Make sure the switch is i
5Grounding Instructions Caution: This tool must be grounded while in use to protect the operator from electric shock. In the event of a malfunctio
6230 Volt Operation If 230V, single phase operation is desired, the following instructions must be followed: 1. Disconnect the machine from the po
7Specifications PDS-12CS Stock Number...
8Contents of the Shipping Carton PDS-12CS 12” Disc Sander 1. Sander 1. Sanding Disc 1. Table 1. Miter Gauge 1. Miter Gauge Fence 1. Owner's Ma
9Stand Assembly 1. With the help of another person lift the sander (A, Fig. 1) onto the stand (B, Fig. 1). Feed the belt (C, Fig. 1) through the c
Comments to this Manuals