Jet Tools JMS-12SCMS User Manual download pdf (Page 15)

Installing Blade

Important: This machine requires a 12-inch

diameter blade.

Unplug the miter saw before changing and/or

installing the blade.

Referring to Figure 7:

1. Install a 12 in. blade with a 5/8 in. arbor (or a 1

in. arbor with a 5/8 in. reducer) making sure the

rotation arrow on the blade matches the

clockwise rotation arrow on the upper guard,

and the blade teeth are pointing downward.

2. Place the arbor collar (G) against the blade and

on the arbor. Thread the arbor bolt (H) on the

arbor in a counterclockwise direction.

Important: Make sure that the flat edge inside

the blade collar opening is aligned with the flat

edge on the arbor shaft. Also, the flat -side of

the arbor collar (G) must be placed against the

blade (J).

3. Place the blade wrench on the arbor bolt (H).

4. Press the arbor lock (E), holding it in firmly

while turning the blade counterclockwise

(opposite the cutting direction of the blade).

When it engages, continue to press the arbor

lock (E) in, while tightening the arbor bolt (H)

securely.

5. Rotate the cover plate (B) back to its original

position until the slot in the cover plate engages

with the cover plate screw (C). While holding

the lower blade guard (A) up as shown, tighten

the screw (C) with a cross-point screwdriver.

6. Lower the retractable blade guard (A) and

verify that the operation of the guard does not

bind or stick.

7. Turn the blade to disengage the arbor lock (E);

then verify that the blade will spin freely.

Never use the saw without the

cover plate securely in place. Failure to comply

may cause serious injury!

The cover plate keeps the arbor bolt from falling out

if it accidentally loosens, and helps prevent the

spinning blade from coming off the saw.

Verify that the collars are clean

and properly installed. Lower the blade into the

table and verify that it does not come in contact

with the metal base or the turn table. Failure to

comply may cause serious injury!

Figure 7

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 39 40

Comments to this Manuals

No comments

Jet Tools JMS-12SCMS User Manual Page 15

Comments to this Manuals