Jet Tools JMS-12SCMS User Manual download pdf (Page 22)

Sliding Fence

The sliding fence must be

extended to the left or right when making bevel

cuts. Failure to comply may cause serious injury!

Failure to extend the sliding fence will not allow

enough space for the blade to pass through. This

could result in serious injury. At extreme miter or

bevel angles the saw blade may also contact the

fence resulting in damage to equipment as well as

personal injury.

The right side sliding fence must be removed when

making any right bevel angle cuts greater than 35º

in combination with any right hand miter angle. This

fence must also be removed whenever a 45º bevel

angle is desired with a miter angle greater than

22.5º.

To adjust the sliding fence (refer to Figure 24):

1. Unlock the fence cam locking lever (A) (shown

locked in Figure 24) by pushing it toward the

rear of the machine.

2. Extend the fence (B) by sliding it out (C) to

match the degree of the bevel cut. Lock the

fence cam locking lever (A) as shown.

Note: Secure the sliding fence in position closest to

the saw blade when transporting the saw.

Removing or Installing the Sliding Fence

Removing

1. Unlock the fence cam locking lever (A, Fig. 24

shows the locked position).

2. Lift up on the sliding fence to remove.

Installing

1. Place the sliding fence onto the miter saw fence

making sure to align the nut on the sliding fence

with the slot in the stationary fence.

2. Lock the sliding fence by push the cam-locking

lever in as shown (A, Fig. 24)

Sliding Carriage System

To reduce the risk of injury,

return carriage to the full rear position after

each crosscut operation.

For a chop cutting operations on small

workpieces, slide the cutting head assembly

completely toward the rear of the unit and

tighten the carriage lock knob (A, Fig. 25).

To cut wide boards up to 12-1/4 in., the carriage

lock knob (A, Fig. 25) should be loosened to allow

the cutting head to slide freely.

Figure 24

Figure 25

To avoid injury from materials

being thrown, always unplug the saw to avoid

accidental starting, and remove small pieces of

material from the table cavity. The table insert

may be removed for this purpose, but always

reattach the table insert prior to performing a

cutting operation.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 39 40

Comments to this Manuals

No comments

Jet Tools JMS-12SCMS User Manual Page 22

Comments to this Manuals