Jet Tools JMS-12SCMS User Manual download pdf (Page 16)

Adjustments

Before attempting any adjust-

ments – To avoid injury from unexpected

starting or electrical shock make sure the

trigger is released and remove the power cord

from the power source. Failure to comply may

cause serious injury!

Note: Your miter saw was adjusted at the factory.

However, during shipment slight misalignment may

have occurred. Check the following settings and

adjust if necessary prior to using this miter saw.

Bevel Stop Adjustments

90°(0°) Bevel Adjustment

1. Turn the bevel lock handle (A, Fig. 8) clockwise

to loosen and tilt the cutting arm while pushing

the bevel detent pin (E, Fig. 10) in against the

0° bevel stop. Turn the bevel lock handle (A,

Fig. 8) counterclockwise to tighten.

2. Place a combination square on the miter table

with the rule against the table and heel of the

square against the saw blade.

If the blade is not 0° to the miter table:

3. Using a 5mm hex wrench, loosen four

adjustment bolts (B, Fig. 9) at the back of the

miter saw. Unlock the bevel lock handle (A, Fig.

8) and position the cutting arm to be zero

degrees to the table using the combination

square as your reference.

4. Tighten the bevel lock handle (A, Fig. 8) and

the four adjustment bolts (B, Fig. 9).

Bevel Scale Indicators

1. Set the blade to be exactly 90°(0°) to the table.

2. With cross-point screwdriver, loosen two bevel

indicator screws (C, Fig. 9).

3. Adjust bevel indicators (D, Fig. 9) to the “0”

mark on the bevel scale and retighten the

screws (C, Fig. 9).

45° Left Bevel Positive Stop Adjustment

1. Set the miter angle to zero degrees. Fully

extend the sliding fence completely to the left

then pull the bevel detent pin (E, Fig. 10) out.

Note: When retracting the bevel detent pin, it

may be required to slightly shift the upper arm

assembly right or left.

Figure 8

Figure 9

Figure 10

Figure 11

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Comments to this Manuals

No comments

Jet Tools JMS-12SCMS User Manual Page 16

Comments to this Manuals