Jet Tools JMS-12SCMS User Manual download pdf (Page 24)

33.9° Bevel Detent Pin for Crown

Moldings

Note: A bevel detent pin is incorporated into this

machine for quick bevel adjustments when the

desired bevel angle is 33.9°.

Referring to Figure 27 (except where indicated):

1. Push the bevel detent stop pin (E) in.

2. Loosen the bevel lock handle (A).

3. Rotate the cutting head (D, Fig. 28) until the

bevel detent pin (E) stops the bevel angle at

33.9° on the bevel scale (F).

4. Tighten the bevel lock handle (A) before you

make your cut.

Compound Cuts

Referring to Figure 27:

Setting the bevel angle

1. Extend the fence by sliding it out to the

required location or remove the right sliding

fence if necessary. (See Sliding Fence or

Removing or Installing the Sliding Fence on

page 22).

2. Loosen the bevel lock handle (A).

3. Set the desired bevel angle; then lock the bevel

lock handle (A).

Setting the miter angle

4. Set the desired miter angle and lock into

position. See Miter Cut.

5. Unlock the miter table by lifting up on the quick-

cam miter table lock (D).

6. Raise the positive stop locking lever (C) up, at

the same time grasp the miter handle (B) and

rotate the miter table left or right to the desired

angle.

7. Release the positive stop locking lever (C).

8. Lock the miter table by pressing down on the

quick-cam miter table lock (D).

90º Crosscut – Narrow Boards

For 90º crosscut operations on small workpieces

(refer to Figure 29):

1. Slide the cutting head assembly completely

toward the rear of the unit and tighten the

carriage lock knob (F).

2. Position the cutting head to the 0° bevel

position and lock the bevel lock handle (C).

3. Position the table to the 0° miter angle and lock

the quick cam miter table lock (D).

Figure 27

Figure 28

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 39 40

Comments to this Manuals

No comments

Jet Tools JMS-12SCMS User Manual Page 24

Comments to this Manuals