Jet Tools JMS-12SCMS User Manual download pdf (Page 20)

Presetting the Cutting Depth

The depth of cut can be preset for even and

repetitive shallow cuts.

Referring to Figure 21:

1. Pull hold-down latch (C) out.

2. Flip the stop plate (A) counterclockwise to the left.

3. Adjust the cutting head down (See Cutting

Head section) until the teeth of the blade are at

the desired depth.

4. While maintaining the cutting head in the

desired position, turn the stop knob (B) until it

touches the stop plate (A).

5. Recheck the blade depth by moving the cutting

head front to back through the full motion of a

typical cut along the control arm.

Figure 21

Rear Support Bar

Do not operate the saw without

the rear extension support bar. Failure to comply

may result in serious injury!

Loosen the two screws (A, Fig. 22) and extend the

rear extension support bar (B, Fig. 22) by sliding it

out, then tighten the two screws.

Figure 22

Laser Beam

The laser is turned on with a switch located on the

saw handle (C, Fig. 23). When left on indefinitely, a

sensor will turn the laser off after 20 minutes. The

switch must be reset (turned off for two seconds,

then on again) to restart.

The laser has no adjustments and should not

require adjustment. If adjustment should become

necessary, take the miter saw to an approved

service center.

• Laser radiation. Avoid direct eye exposure.

Always un-plug miter saw from power

source before making any adjustments.

• Laser Warning Label: Max output <1mW

DIODE LASER: 522-542nm, Complies with

21CFR 1040.10 and 1040. 11.

LASER RADIATION

AC UTION

LASER RADIATION

AC UTION

LASER RADIATION

DO NOT STARE INTO BEAM

CLASS II LASER PRODUCT

MAX OUTPUT <1mW, DIODE LASER 522-542nm

COMPLIES WITH 21CFR 1040.10 AND 1040.11

CAUTION

Use of controls or adjustments

or performance of procedures other than those

specified in this manual may result in

hazardous radiation exposure.

The use of optical instruments

with this product will increase eye hazard.

• Do not attempt to repair or disassemble the

laser. If unqualified persons attempt to

repair this laser product, serious injury may

result. Any repair required on this laser

product should be performed by authorized

service center personnel.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 39 40

Comments to this Manuals

No comments

Jet Tools JMS-12SCMS User Manual Page 20

Comments to this Manuals